A-A-403C
B. Sampling. Sampling for inspection and tests shall be performed in accordance with MIL-STD-105, except where otherwise specified. For purposes of sampling, a lot shall consist of all clips of the same description manufactured under the same conditions at essentially the same time.
1) Sampling for visual inspection. A random sample shall be taken from each lot in accordance with inspection Level S-3. The AQL shall be 2.5 percent defective. Sample shall be examined for defects listed in Table III. The sample unit shall be one clip.
2) Sampling for dimensional inspection. A random sample shall be taken from each lot in accordance with inspection level S-2. The AQL shall be 2.5 percent defective. Sample shall be examined for defects listed in Table III. Sample unit shall be one clip.
3) Sampling for tests. A random sample shall be taken from each lot in accordance with inspection level S-2. The AQL shall be 2.5 percent defective. The sample unit shall be one clip. The sample unit shall be performance tested as required by paragraphs 2A & B. Any unit not meeting the test criteria will be counted as a defective unit.
4) Packaging, packing, and marking- Inspection level S-2 with an AQL of 4.0 percent defective. The sample unit shall be one fully prepared shipping container.
4. Recovered Materials
“The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).”
5. Application for copies of technical documents referenced herein: The issue date in effect on the date of invitation for bids or request for proposal shall apply.
MIL-STD-105 is available from Naval Publications and Forms Center; 5801 Tabor Avenue; Philadelphia, PA 19120.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business