C. Performance Test - Each sample shall be sharpened and tested by drawing a line 60 cm under ordinary writing pressures. The lines shall show uniformity of color and evenness as required by this specification. ~en drawing a line, the lead shall work smoothly without grittiness on bond paper.
III. Regulatory requirements. The offeror/contractor is encouraged to use recovered materials in accordance with Public Law 94-580, as amended, to the maximum extent practicable.
IV. Hazardous material requirements.
A. Material Safety Data Sheets. Safety data shall be furnished in accordance with Fed.Std.313. The pertinent government mailing addresses for submission of data are listed in appendix B of Fed.Std.313.
V. Quality Assurance Requirements.
A. Responsibility for inspection. Unless otherwise specified in the contract or purchase order (see ordering information), the supplier is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified, the supplier shall utilize his own facilities or any commercial laboratory acceptable to the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
B. Lot definition. Each lot of pencil shall be inspected for conformance to the requirements herein. Inspection shall be in accordance with MIL-STD-105 using the sampling plans specified below. The lot shall be expressed in pencils manufactured from the same materials, at essentially the same time.
C. Examination of the end item for visual defects. The sample unit for this examination shall be one pencil. A random sample shall be taken from each lot in accordance with Inspection Level S-3. The AQL shall be 2.5 percent defective. Samples shall be examined for defects listed below. Any pencil containing one or more defects shall be rejected.
|
Examine |
Defects |
|
Workmanship |
See Workmanship paragraph |
|
Appearance |
Not as specified. |
|
Material |
Not as specified |
|
Casing |
Not glued together. |
|
Eraser |
Loose and not as specified. |
D. Examination of the end item for dimensional defects. The sample unit for this examination shall be one pencil. A random
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business