A-A-247A
TABLE I.
Fasteners (in inches)
|
Fastener Commercial Size Number |
Long Prong Length + 1/16 |
Width +1/64 |
Thickness + 1/64 |
Head Diameter + 1/32 |
Washers Commercial Size Number |
|
4 |
1 |
1/8 |
0.012 |
13/32 |
1 |
|
7 |
2 |
3/16 |
0.016 |
15/32 |
2 |
|
8 |
3 |
3/16 |
0.016 |
15/32 |
2 |
2. Quality Assurance
Responsibility for Inspection: Unless otherwise specified in the contract or purchase order, the supplier’s in responsible for the performance of all the inspection requirements in this CID. Except as otherwise specified, the supplier may use his own facilities or any commercial laboratory acceptable to the Government. The Government reserves the right to perform any of the inspection set forth in the Commercial Item Description, where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
Each lot of fasteners shall be inspected for conformance to the requirements herein. Sampling for inspection shall be in accordance with MIL-STD-105 using the plans specified below.
A. Sampling Plan for Test (see 2E), Inspection Level S-2 with an Acceptable Quality Level (AQL) of 4.0 percent defective. The sample unit shall be one fastener.
B. Visual characteristics - Inspection Level S-2 with an Acceptable Quality Level (AQL) of 4.0 percent defective. The sample unit shall be one fastener.
C. Dimensional Characteristics - Inspection Level S-2 with an Acceptable Quality Level (AQL) of 4.0 percent defective. The sample unit shall be one fastener.
D. Packaging, Packing, and Marking – Inspection Level S-2 with an AQL of 4.0 percent defective. The sample unit shall be one fully prepared shipping container.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business