A-A-2767
3.7 Hazardous Materials.
3.7.1 Toxicity- Use of any toxic substance must be in accordance with all applicable federal statutes. The harmful substances shall be defined as the poison and injurious substances as designated in Fed Std. 313. The vendor shall prepare a certification that the ink conforms to the above requirements.
3.7.2 Material safety data sheets - Safety data shall be furnished in accordance with Fed.Std.313. The pertinent government mailing addresses for submission of data are listed in Appendix B of Fed.Std.313.
3.7.3 Labeling- Containers shall be labeled to comply with the “Federal Hazardous Substances Act Regulations”, 16 Code of Federal Regulations, Part 1500.
3.8 Shelf Life. The markers shall be able to meet all the requirements of this specification from the time of delivery to a minimum of 12 months in storage. Suppliers shall replace, without cost to the Government, all markers failing to meet this requirement.
4. QUALITY ASSURANCE REQUIREMENTS.
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the supplier is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified, the supplier may utilize his own facilities or any commercial laboratory acceptable to the Government. The Government reserves the right to perform any of the inspection set forth in the specification where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
4.2 Sampling and inspection. Lot definition - Each lot of markers shall be inspected for conformance to the requirements herein. Inspection shall be in accordance with MIL-STD-105 using the sampling plans specified below. The lot shall be expressed in markers manufactured from the same materials, at essentially the same time.
4.3 Inspection.
4.3.1 Inspection of materials and components. The supplier is responsible, in accordance with 4.1, above, for insuring that components and materials used were manufactured, tested, and inspected in accordance with the specified requirements of referenced subsidiary specifications and standards and in accordance with this specification, as applicable.
4.3.1.1 Examination of the end item.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business